Documentation menu
Draw by hand

Electrical & wiring

Fixtures, switches, the Wire tool, Auto-wire and the X-ray wiring view.

Electrical fixtures are real parametric objects mounted on walls and ceilings. A switch stores the loads it controls; every switch is fed from the plan’s single Main Switch. That relation is what the X-ray view draws and what the wiring-diagram PDF is generated from.

Fixtures#

FixtureMounts onSettings
Main SwitchWallOne per plan — every switch is fed from it automatically.
SwitchWallCircuit; which loads it controls.
Plug / SocketWallAmperage (3 A, 5 A, 15 A), circuit.
Bulb / Light PointCeiling or wallWattage, circuit.
FanCeilingWattage, blade span, circuit.

Every fixture has Position U / Position V on its host surface (along the wall and height, or across the ceiling), a Spin, and — on walls — which Wall Face it’s on.

Wall Mode#

Click ⚡ in the bottom toolbar. A fixture picker appears at the top of the 3D view and the house turns X-ray.

  1. Place fixtures

    Choose Plug, Switch, Main Switch, Bulb or Fan, then click a wall or ceiling. The fixture lands exactly where you clicked, on the face you clicked. Ceiling fixtures need a Ceiling component above the room.

  2. Wire with the 🔌 Wire tool

    Click a switch, then click each light, fan or plug it should control (click a connected one again to disconnect). You can click straight through the see-through walls, and a click lands on the nearest fixture within about 25 px.

  3. Or press Auto-wire

    Every light and fan without a switch is wired to its nearest switch, and every switch is fed from the Main Switch — one undo step.

Reading the X-ray view

ColourMeaning
RedFeed: Main Switch → switch
YellowSwitched run: switch → light / fan / plug
GreenRuns of the fixture you've picked with the Wire tool

Runs are drawn the way they’re concealed on site: up inside the wall from the fixture to the ceiling void, across the void, and down inside the other fixture’s wall.

Wiring diagram PDF#

File → Export → PDF (Wiring Diagram) (or the wiring button on a plan in your Projects page) produces three sheets:

  • Circuit diagram — a single-line ladder: Main Switch → switches → loads, with standard symbols, wattages and plug ratings. Unswitched plugs are fed straight from the main board.
  • Wiring layout — the floor plan with every fixture at its real position and switched runs as curved dashed arcs, one colour per switch.
  • Fixture schedule — label (MS, S1, L1, F1, P1…), mounting, circuit, rating, what controls it and what it controls, plus circuit totals.
Note
Lights and fans with no switch are flagged in red as unassigned on every sheet. Plugs don’t need a switch.